Advertisement
Mount the rear panel onto the enclosure, using two M4 Allen screws.
Connect the speaker wires to the speaker output tabs. Check the polatity!
Black= LS-, Red= LS+.
DO NOT CONNECT THE MAINS WIRING WITH THE PCB YET!
!
29. Preparing the front panel
Connect the two wired connector to the meter, RED =
+, BROWN = - to the meter.
Mount the power meter onto the front panel.
Fix the meter using a piece of transparent adhesive
tape (four sides).
Make sure the meter is positioned straight.
Connect the meter to the PCB (SK8)
Mount the front panel onto the front, using two M4
Allen screws.
Check the position of the LED's and check if the button is working correctly.
It could be that paint covering the holes, is preventing the buttons from
smooth operation.
Now the three PCB fixations can be tightened.
Check the push button.
Final assembly
19
Advertisement
