Advertisement
Using an ohmmeter, measure between the edge of the aluminum profile and
the back spacer, if there is a good electric contact (less then 10 ohm).
If not, repeat the above step to remove the paint under the spacer.
Slide two M3 nuts and two
hexagonal bolts into the profile,
the nuts will be used for the
temperature sensor, the bolts will
be used for the IC support plate:
Mount the temperature sensor,
check the exact position. Make sure
there is silicone compound between
the sensor and the enclosure!
Solder the wires of the supplied two
pole connector onto the sensor.
There is no polarity.
FIG. 7
FIG. 8
FIG. 9
Enclosure preparation
15
Advertisement
