Advertisement
Enclosure preparation
Position the main PCB in the aluminum profile that is prepared with the feet.
Mark the center position of
the three fixation holes on
the aluminum. A reference
indication is also on the
PCB edge.
Remove the pcb and use a knife or a screwdriver to scratch the paint from
the aluminum fixation, from the hole closest to the back end. This fixation will
be used later to connect the ground and earth.
FIG. 5
Mount the three 5mm (0.14") spacers as shown in the drawing. Use three
hexagonal screws and 3 washer. Do not tighten the spacers yet.
5mm M3 spacer
Position the PCB in the enclosure and check if the position of the spacers is
correct, if so, remove the PCB and tighten the spacers.
14
FIG. 4
FIG. 6
M3 hex. nut
Washer
Advertisement
