Advertisement
27. Speaker and mains connector assembly
Prepare the wiring of the mains connector like in the drawing.
First mount the switch into the mains connector assembly.
Do not forget to isolate the soldering connections using a piece of shrink tube.
Use the supplied 0.5mm wire:
Blue for Neutral
Brown for Live
Yellow/green for earth
Use 3 pieces of about 10cm for later connection to the PCB mains connector.
Brown
Blue
Yellow/green
Mount the speaker connectors onto the rear panel. (black = negative)
Take care of the isolation washers, there are two different types!
See picture.
Make sure the connectors are very tight fit, and do not make electrical
contact with the panel (check using ohm meter!).
Final assembly
Isolation washer !
17
Advertisement
