Setting Custom Programmes - Verity Medical NeuroTrac MultiTENS Operator's Manual

Setting Programme Time for pre-set programmes
1. Select P01 ~ P17 using the PRG 1 button.
2. Press the SET button and the Clock symbol will flash ON/OFF,
then press the either + or – button to adjust the time between:
TENS Programmes 1-13: 30 minutes, 1 hour, 4 hours, 9 hours,
CON (continuous).
NMS Programmes 14-17: 30 minutes, 1 hour, 2hours.
3. Press ESC to save the time for the selected programme.

Setting Custom Programmes

1. Select PC1, 2 or 3 by pressing the PRG 1 button on the front panel.
Remove the battery lid where you will see two buttons SET and
ESC.
2. Press the SET button once to customise a single phase.
Hold the SET button for three seconds to enter advance mode and
customise up to 5 phases. Press the SET button once to select the
phase.
3. Press B + / - to set the phase time.
Press A + to select the phase mode.
4. Press B + / - to select the phase mode: continuous (CON),
modulated (MOD), burst (BST), Neuromuscular stimulation
(NMS).
Press A+ to configure the phases parameters.
CON (continuous TENS mode)
1. Press B + / - to set the frequency (Hz) between 2Hz and 200Hz
Press A + to set the Pulse Width.
2. Press B + / - to set the pulse width (µS) between 50µS and 450µS.
NOTE: If frequency 105 Hz or higher is set, the pulse width will
be restricted to 300µS maximum for safety.
3. Press the SET button to configure the next phase or press the ESC
button to save the parameters.
NeuroTrac MultiTENS Operation Manual
®
10
next