Charging The Speaker - Dcybel Paris Instruction Manual

Accesories
3.5 mm audio cable
Micro USB cable
When the USB cable is used as the
disconnect device, the disconnect device
shall remain readily operable.
The marking plate is located at the rear of
the apparatus.

CHARGING THE SPEAKER

The speaker has a built-in Lithium battery. It
is recommended to charge the internal
battery for about 2 hours before using the
speaker.
The fully-charged battery can give up to 7-
hour playing time at 50% volume depending
on genres of music and volume.
1.Connect the micro USB plug end of the
supplied cable to the charging port on the
back of the speaker. Connect the standard
USB plug end of the cable into the USB
port on your computer or other USB
charging device.
The indicator light will illuminate red.
2. When the indicator light goes out, the
battery is fully charged.
3. After charging, remove the micro USB
cable.
EN-5
Low battery warning: When you hear two
beeps at regular intervals, please recharge
the speaker.
PARING WITH A BLUETOOTH-ENABLED
DEVICE
1. Turn on the speaker.
The speaker will enter Bluetooth mode
and the indicator light will flash blue quickly.
2. To pair, go to Bluetooth settings on your
Bluetooth enabled device and connect to
"Paris".
Enter "0000" if asked for a passcode.
Mode
Status
The indicator light will flash blue
Bluetooth
pairing
quickly.
You will hear jingle sound and the
indicator light will flash blue slowly
at regular intervals.
NOTE:
Once the Bluetooth device is
connected for the first time, the
Paired
speaker will remember the paired
setting and will automatically
reconnect to the same Bluetooth
device the next time they are in
range.
EN-6