Installation; Pairing Speaker With A Bluetooth Device - Dcybel SKYLINE Instruction Manual

INSTALLATION

PAIRING SPEAKER WITH A BLUETOOTH DEVICE

1. Connect the supplied power adapter to the DC IN jack of the speaker and then plug
the power adapter into the mains socket.
2. Press on the speaker or on the remote control to turn on the unit.
3. Repeatedly press SOURCE on the speaker or on the remote control until the
Bluetooth indicator light flashes GREEN.
4. Turn on the Bluetooth function of the device and place the device near this unit.
5. Set your Bluetooth enabled device to search the speaker and select "SKYLINE" from
the list of found devices.
• Note: If you are required to enter a PIN code, enter 0000.
6. Once pairing is successful, the Bluetooth indicator light will become solid GREEN.
7. Start play on the Bluetooth device.
•The effective operation range between the unit and the paired Bluetooth device is
approximately 10 metres in the open area.
•This unit can only be connected to one device at a time.
•When you select the Bluetooth source, this unit will automatically connect to the last
connected Bluetooth device. The Bluetooth device will be disconnected if a different
audio source (e.g. AUX) is selected.
Disconnecting a Bluetooth device
While a Bluetooth device is connected, press and hold
seconds or press PAIR on the remote control to disconnect current pairing.
The Bluetooth indicator light will flash GREEN.
Attach the base to the main
body using the supplied screws
and washers.
on the speaker for about 2
EN-5