Basic Instructions - Case 570ST The KING Service Manual

Basic instructions

WARNING
Crushing hazard!
If you service the machine with the loader lift arms raised, always use the support strut. Remove the
retaining pin and place the support strut onto the cylinder rod. Install the retaining pin into the support
strut. Lower the lift arms onto the support strut.
Failure to comply could result in death or serious injury.
Raise and support loader lift arms:
1. Empty the loader bucket.
2. Raise the loader lift arms to the maximum height.
3. Shut down the engine.
4. Remove the retaining pin.
5. Lower the support strut onto the cylinder rod.
6. Install the retaining pin.
7. Start the engine.
8. Slowly lower the lift arms so that the end of the support
strut rests on the cylinder.
INTRODUCTION
51523349 31/08/2018
14
W0230A
1
RCPH10TLB230AAF
2
RCPH10TLB221AAF
3
RCPH10TLB227AAF