Personal Safety - Case 570ST The KING Service Manual

INTRODUCTION

Personal safety

1. Make sure to arrest all fuel leaks. Any fuel or oil spilled on hot surface or electrical components may cause fire
accidents. Make sure that the machine is sealed from leakage.
2. Do not allow straw, trash, bird nests or flammable material in the machine and remove the same as they can ignite
fire on hot surfaces.
3. Make sure the fire extinguisher installed on or near the machine. If already equipped, the fire extinguisher is
maintained and serviced according to the manufacturer's instructions.
4. Check and make sure to clean all the trash from the machine especially around hot components such as the
engine, transmission, exhaust, battery, etc. Do these checks and clean the machine at least once a day, probably at
the end of the day. More frequent checks and cleaning of machine may be necessary depending on the operating
environment and conditions.
5. Inspect the electrical system for loose connections and frayed insulation. Repair or replace the loose or damaged
parts.
6. Check and remove the debris accumulation around moving components such as bearings, pulleys, belts, gears,
cleaning fans, etc. More frequent cleaning of the machine may be necessary depending on the operating environment
and conditions.
7. Check all fuses, relay, and MCB's for correct ratings and validity. Replace the defective or non-complaint parts. Do
not to bypass/override/tamper any safety systems of the machine.
8. Check and remove any oily rags or other flammable material on the machine. Do not to store such material around
or on the machine.
9. Make sure that do not weld or flame cut any items that contain flammable material. Clean the items thoroughly
with non-flammable solvents before welding or flame-cutting.
10. Immediately investigate any unusual smells or odors that may emerge during operation of the machine. Always
aware of such observations and actions thereof.
11. Make sure that the machine is serviced only by authorized CASE CONSTRUCTION dealer service team and not
by any external parties.
12. Check and remove any non-recommended devices that are fitted on the machine. Do not to use any devices that
are not a standard fitment by the company.
13. The personnel make sure that they do not smoke or use mobiles while refuelling. It is not advisable to park
the machine near a place which poses fire hazard (Workshops where welding, grinding, gas cutting etc is underway,
bonfires etc).
NOTICE: Any damage to the machine due to non-adherence of the above guidelines and instructions may lead the
warranty void for the machine.
51523349 31/08/2018
8