Remove Visor Mount Clips And Base - Toyota CAMRY PT949-08210 Installation Instructions Manual

TOYOTA CAMRY
Procedure
Fig. 4-5
Fig. 4-6
Fig. 5-1
Issue: A 07/25/2021
2022 -
(GAS AND HV)
Page 4 of 16 pages
DASHCAM
For Dealer Installations / No 3D Hard
Template Available:
(g) Using scissors, cut the paper template as
indicated. For PPO Installations, please
use 3D hard template provided.
(h) Referencing the TSS cover, align to the
indicated line and affix the template to
the windshield using tape. (Fig 4-5)
(i) Remove adhesive and stick mounting
plate on windshield paying attention to
the reference lines on template. Press
firmly to reduce visible air pockets. Note
that the narrow end of the plate is
towards the top of the windshield.
(Fig 4-6)
(j) Once the base plate is fitted, remove
template in the direction towards the
lower edge of the windshield and clean
any tape residue from the glass.
All Installation types continue from here
onwards.

5. Remove Visor Mount Clips and Base

(a) Remove the Sun Visor Hooks on BOTH
Driver and Passenger side of the Map
Light Console, to allow for gentle pulling
down of the headliner without damage.
Note: Both sides remove in the same
direction, Passenger side is not mirrored.
(1) Twist the Visor Hook Anti-Clockwise
and pull down to release hook
component. (Fig 5-1)
(2) After removing the hook component,
release the two tabs and pull out the
base, needle nose pliers
recommended.
(Digital Video Recorder)