Installation; Wall (Or Vertical Surface) Mounting - Black Box 10BASE-T Manual

10BASE-T MINIHUB
Installation of a 10BASE-T MiniHub
is a very simple procedure. First,
locate the Ethernet device that will
provide power to the Hub through
its AUI port), and connect a
transceiver cable (LCN210 or
LCN200) between that device and
the Hub. When power is applied the
green "PWR" LED will light.
3.1 Table-Top or Shelf Mounting
The 10BASE-T MiniHub is easily
mounted on a table-top or shelf, and
has four rubber feet to provide
stability and keep it from scratching
finished surfaces. A piece of Velcro
may be used to add additional
stability if desired. When properly
installed, the LED status indicators
will be in plain view and easy to read.
Plug in two or more Ethernet cable
segments, and your network is in
operation.
The rugged steel case of the
10BASE-T MiniHub will protect it
from accidental damage in an office
or lab setting. Keep an open area
around the unit so that convection
cooling can occur while the unit is
in operation.
12

3. Installation

3.2 Wall (or Vertical Surface)
Mounting
A piece of Velcro mounting tape is
supplied with the unit, and may be
used to mount a MiniHub in a
vertical position. Stick one side of
the Velcro on the bottom of the
MiniHub between the rubber feet.
Stick the other side of the Velcro
to the desired vertical mounting
location. This permits the compact
hub to be mounted on a wall
surface, on the side of a server unit
cabinet, on the back of a desk, or in
other similar convenient locations in
the workplace where the associated
cables are out of the way.