Edition
Manual
2014-09-23 Workshop Manual, GGP Park 7 Electrical System
7.3.3 Connections
The machine is equipped with three kinds of
connectors:
• Fixed connectors in plastic holders.
• Tab connectors
• Screw connectors
All connectors shall be kept free from
contamination, corrosion and damp.
Fixed connectors in plastic holders
To remove the connectors from the plastic
holder, put a small screwdriver behind the
connector, hold the cable and pull out the
connector.
See the figure.
Tab connectors
To restore tab connectors if bad crimp forces
occur, e.g. after a long time of use, the
connector can be pinched by a pliers.
See the figure.
Screw connectors
When cables shall be connected into screw
connectors, the cable shall be stripped off 5
mm only. No metallic conductor is allowed to be
exposed outside the terminal.
Warning!
Exposed conductors can cause short-
circuit and fire.
Chapter
Page
45