EMS FirePoint 5000 Communications Manual page 15

EMS 5000 FIREPOINT
31 Press the "" button and the screen will display:
32 Press the "YES" key and the screen will display:
33 The collector should be set to "ENABLED", press the
"YES" key to change its status. Once set to "ENABLED"
press the "NO" key and the screen will display:
34 Press the "NO" key and the screen will display:
35 Press the "" button until the screen displays:
36 Press the "YES" key and the screen will display:
37 Press the "YES" key and the screen will display:
38 Enter "00" followed by the "YES" key unless the NUA is
already set to 00. In which case press the "NO" key.
The screen will display:
39 Press the "" button until the screen displays:
40 Press the "YES" key and the screen will display:
41 The Routing should be set to "ENABLED". If already
set, press the "NO" key. (If "DISABLED" press the
"YES" Key followed by the "NO" key. The screen
should now display:
©2015 EMS Security Group Ltd. All rights reserved.
15
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select
| Enable Receiver |
> Enable Collector <
| Monitor Traffic |
Yes= Select
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select
| Checksum Data |
> Network Router <
| Radio LAN
Yes= Select
|*
NETWORK ROUTER
> Setup local NUA
| View network NUA|
Yes= Select
Local NUA : 00
Input Local NUA
Yes= Finish
|*
NETWORK ROUTER
> Setup local NUA
| View network NUA|
Yes= Select
| Network Name
> Control Routing <
| Send Test
Yes= Select
Routing : DISABLED
Push YES to change
Push NO to escape
Yes/No
| Network Name
> Control Routing <
| Send Test
Yes= Select
| Network Router
> Radio LAN
TSD234 Iss 3 25/06/15 AJM
| Fire DB
Yes= Select
Time
Time
|
<
|
Time
|
Time
*|
<
Time
Time
*|
<
Time
|
|
Time
Time
|
|
Time
|
<
|
Time