Step By Step Software Configuration - EMS FirePoint 5000 Communications Manual

EMS 5000 FIREPOINT

11. Step By Step Software Configuration:

Note: it is assumed that all installation procedures are complete.
Firstly, insert the Key into the Panel's Control Keyswitch, located at the right of the
Panel. Turn the Key to the "ON" Position.
Step
No
1 Press the "0" key followed by the "" button until the
screen displays:
2 Press the "YES" key and the screen will now display:
3 Press the "" button until the screen displays:
4 Press
now display:
5 Enter 221100 then press the "YES" key and the
screen will now display:
6 Press the "" button until the screen displays:
7 Press the "YES" key followed "0" key on the Keypad
the screen will now display:
8 Press the "" button until the screen displays:
9 Press the "YES" key. The screen will now display:
©2015 EMS Security Group Ltd. All rights reserved.
Action
the "YES" key
Screen Display
and the screen
12
| Logging
>Fire System Opts <
| Remote Access
Yes = select
| ** Fire system ** |
>Dev. Disable/Test<
| Net. Disable/Test |
Yes= Select
| System Mode
>Engineers Config <
| Printer Options
Yes= Select
Enter Your PIN
will
For Access>
Then Press YES
| ** Eng.; Config ** |
> Device Database <
| Sounder Options |
Yes= Select
| Reset Security
> Reset System
| LAN Options
Yes= Select
|** Main Menu **
> Pins & Access
| System Support
Yes= Select
| System Support
> Serial Comms
| Pager Setup
Yes= Select
|* Serial Comms
> Device Table
| Re-start bus
Yes= Select
TSD234 Iss 3 25/06/15 AJM
|
|
Time
Time
|
|
Time
Time
Time
|
<
|
Time
|
<
|
Time
|
<
|
Time
*|
<
|
Time