EMS FirePoint 5000 Communications Manual page 14

EMS 5000 FIREPOINT
21 Press the "" button once and the screen will display:
22 Press the "YES" key. The screen will now display:
23 Press the "0" key followed by the "YES" key and the
screen will display:
24 Press the "NO" key and the screen will now display:
25 Press the "NO" key and the screen will now display:
26 Press the "" button until the screen displays:
27 Press the "YES" key. The screen will now display:
28 Press the "" button until the screen displays:
29 Press the "YES" key and the screen will display:
30 The Rem Rxer should be set to "DISABLED", press the
"YES" key to change. Otherwise press the "NO" key.
The screen will display:
©2015 EMS Security Group Ltd. All rights reserved.
14
| Reply Baudrate
> Port to use
|^^^^^^^^^^^^^^^|
Yes= Select
Remote Port = 0
0 = Off, 1 = RS485
2 = PAGER 232> _
Yes= Select
| Reply Baudrate
> Port to use
|^^^^^^^^^^^^^^^|
Yes= Select
| Bus Master Setup |
>Bus Remote Setup<
| Pager 232 Redir' |
Yes= Select
| System Support |
>Serial Comms
| Pager Setup
Yes= Select
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select
>
|* Remote Receivers * |
> Receivers Found
| Enable Receiver
Yes= Select
| Receivers Found |
> Enable Receiver <
| Enable Collector |
Yes= Select
Rem Rxer : ENABLED
Push YES to change
Push NO to escape
Yes/No
| Receivers Found |
> Enable Receiver <
| Enable Collector |
Yes= Select
| Enable Receiver |
> Enable Collector <
| Monitor Traffic |
TSD234 Iss 3 25/06/15 AJM Yes= Select
|
<
Time
Time
|
<
Time
Time
<
|
Time
|
<
|
Time
<
|
Time
Time
Time
Time
Time