Table of Contents
Advertisement
Place the burner plates, burner plate
caps and grills back to their seating after
installation.
Making connections to different
holes is not a good practice in
terms of safety since it can
damage the gas and electrical
system.
There are gas and electrical
components contained within this
hob, therefore when fitting the
mounting springs/clamps only
attach the supplied fixings to the
connection holes shown in this
manual. Failure to observe this
advise may lead to life and
property safety
Final check
1. Open gas supply.
2. Check gas installations for secure
fitting and tightness.
3. Ignite burners and check appearance
of the flame.
Flame must be blue and have a
regular shape. If the flame is
yellowish, check if the burner cap
is seated securely or clean the
burner.
Gas conversion
Before starting any work on the
gas installation, disconnect the
gas supply.
There is the risk of explosion!
In order to change your appliance's gas
type, change all injectors and make
flame adjustment for all valves at
reduced flow rate position.
Exchange of injector for the
burners
1. Take off burner cap and burner body.
2. Unscrew injectors by turning the
counter-clockwise.
3. Fit new injectors.
4. Check all connections for secure fitting
and tightness.
New injectors have their position
marked on their packing or
injector table on Injector table,
page 11 can be referred to.
((Varies depending on the product
model.))
On some hob burners, the injector
is covered with a metal piece. This
metal cover must be removed for
injector replacement.
1 Flame failure device (model
dependant)
2 Spark plug
3 Injector
4 Burner
17/EN
Advertisement
Table of Contents
