Beko HIAG64223 SX-D-FICz User Manual page 15

Before starting any work on the
gas installation, disconnect the
gas supply.
There is the risk of explosion!
• Gas adjustment conditions and values
are stated on labels (or on type label).
Your product is equipped for
natural gas (NG).
• Natural gas installation must be
prepared before installing the product.
• There must be a pipe (Piping advised
to be buyed from a licensed installer),
must comply with local gas standard,
at the outlet of the installation for the
natural gas connection of your
product and the tip of this pipe must
be closed with a blind plug. Service
Representative will remove the blind
plug during connection and connect
your product by means of a straight
connection device (coupling).
• Make sure that the natural gas valve is
readily accessible.
If you need to use your product
later with a different type of gas,
you must consult the Authorised
Service Agent for the related
conversion procedure.
Leakage check at the connection
point
• Make sure that all knobs on the
product are turned off. Make sure that
the gas supply is open. Prepare soapy
foam and apply it onto the connection
point of the hose for gas leakage
control.
• Soapy part will froth if there is a gas
leakage. In this case, inspect the gas
connection once again.
• Instead of soap, you can use
commercially available sprays for gas
leak check.
Never use a match or lighter to
make the gas leakage control.
The flexible gas hose must be
connected in a way that it does
not contact the moving parts
around it and is not trapped when
the moving parts are travelling.
(e.g. drawers). Besides, it should
not be placed in spaces where it
might get squeezed.
The gas hose must not be
clamped, bent or trapped or
come into contact with hot parts
of the product.
There is the risk of explosion due
to damaged gas hose.
Installing the product
1. Remove burners, burner caps and
grills on the hob from the product.
2. Turning the hob upside down, place it
on a flat surface.
3. In order to avoid the foreign
substances and liquids penetrate
between the hob and the counter,
please apply the putty supplied in the
package on the contours of the lower
housing of the hob but make sure that
the putty does not overlap.
4. Fill the corners by forming bends at
the corners as illustrated in the figure.
Form as much bend as required to fill
the gap in the corners.
Make sure that the skirting
sections on the lower housing of
the hob are filled with putty.
5. Place the hob on the counter and
align it.
15/EN