Table of Contents
Advertisement
6. Using the installation clamps secure
the hob by fitting through the holes on
the lower casing.
1 Hob
2 Installation clamp
3 Counter
8. If the counter thinkness is smaller to fix
with clamp, it can be used with the
additional pieces. Add the pieces to
clamp according to your counter
height dimensions as shown below.
4 Additional piece
9. To remove pieces from each other, it
should be needed to pull the pin (1) up
and remove the piece.
16/EN
5 Pin
When installing the hob onto a
cabinet, a shelf must be installed
in order to separate the cabinet
from the hob as illustrated in the
above figure. This is not required
when installing onto a built-under
oven.
For example, if it is possible to touch the
bottom of the product since it is installed
onto a drawer, this section must be
covered with a wooden plate.
*
min. 15 mm
Rear view (connection holes)
Location of the connection holes
shown in the below figure are
schematic,may vary depending on
the product model. Fix them
according to connection holes on
your product.
Advertisement
Table of Contents
