First Use Pressing Tin Cans; Cleaning; First Use Pressing Paper And Plastic; Maintenance - Hamach BUGGY 30 User Manual

First use pressing tin cans

The air conduit should not provide a higher pressure than 10 bar. The recommended air pressure for
the Buggy 30 is 6 bar (working pressure). When the pressure is set differently, then you need to reset
it to 6 bar. A pressing table (standard included) should be placed in the press room, in case of
pressing tins.
 After opening the door of the press place empty tins (small models max 3 to 4 or 1 large tin),
Tins have to be empty. It is possible to press multiple small tins at once. Make sure that the
tins are symmetrically placed in this case. This prevents uneven wear of the cylinder and
mechanical parts.
 Close the door of the Buggy 30 (84126). Push the pressure switch (084120). After pressing
the pressing plate returns in its upper position. Open the door and remove the pressed tins.

Cleaning

Big amounts of paint residues in the Buggy 30 should be removed immediately. This can negatively
effect the functioning of the Buggy 30 Combi press.
Attention! When cleaning the Buggy 30, the pressure on the press should be connected.

First use pressing paper and plastic

 Remove the press table out of the press area.
 On top of the press there is a cylinder which is equipped with a rope knot. Lead the beginning
of the rope through the opening on the backside. Place the rope in the slit on the bottom of
the press area and make sure the rope is partly sticking out on the front. This way it is
possible to bind the paper after it is pressed.
 Close and lock the bottom door.
 The top door can be opened so paper, carton and plastic can be placed in the press area. If
the quantity of paper threatens to come out of the press, the top door can be closed and
intermediate the paper can be pressed. If the top door is closed, the switch button can be
pressed to start the press process.
 Unlock the top door to turn the door handle. After a few seconds the press cylinder will go
back to the primary position and the top door can be opened. Now you can continue to fill the
press area with a new quantity of paper. This can be repeated several times until the press is
completely filled with paper.
 After pressing open the top door and fasten the rope around the bundle of paper.
 By opening the latches, you can open the bottom door. Remove the bundle of paper from the
press and close the bottom door.

Maintenance

Regularly check all the screws and functioning of the press as a whole. The press is equipped with a
self-service pressure cylinder, so greasing is not necessary and not recommended. The air unit of the
Buggy 30 provides a water separator (084121). Regularly check if there is no moisture or water in the
reservoir. If necessary remove this water and clean the air unit. Regularly check if air pressure stays at
+/- 6 bar working pressure.

Guarantee

The Buggy 30 Combipress has a guarantee of 2 years starting the date of purchase. The guarantee is
only applicable on workmanship and expires in case of incorrect mounting of the press, abusive use or
not following the instructions in this manual. Claims on warranty are only possible when the warranty
card will be returned to EMM International B.V. in 2 weeks after the date of sale at the latest. When
changes are made to the function of the Buggy 30, every responsibility of the supplier will void. In
case of claims of defects to the Buggy 30, a copy of the bill always needs to be handed over.
9