Replacement Parts - Weber SPIRIT EPX-325S PREMIUM GBS Owner's Manual

BARBECUE WILL NOT IGNITE
SYMPTOM
• Burner does not ignite when following the electronic ignition instructions in the "Operation" section of this Owner's Manual.
CAUSE
There is a problem with gas flow.
There is a problem with the electronic ignition system.
Lighting Your Grill with a Match
Using a Match to Determine if there is
Gas Flow to the Burners
1) Open the barbecue lid.
2) Check that all burner control knobs are in the
off position. Check by pushing in and turning
knobs clockwise.
Note: It is important that all burner control knobs be in
the off position before you turn on the LPG cylinder.
3) Turn gas supply on by turning cylinder valve
anti-clockwise or by moving regulator lever to the
on position depending on your regulator/cylinder
connection.
REPLACEMENT
PARTS
To obtain replacement parts, contact
the local retailer in your area or
log onto weber.com.
20
SOLUTION
If the barbecue will not ignite, the first step is to determine if there is gas flowing to the burners. To check this,
follow the instructions below for "Using a Match to Determine if there is Gas Flow to the Burners."
If match lighting IS NOT successful, follow the gas flow troubleshooting suggestions on the next page.
If the barbecue will not ignite, the first step is to determine if there is gas flowing to the burners. To check this,
follow the instructions below for "Using a Match to Determine if there is Gas Flow to the Burners."
If match lighting IS successful, follow the instructions below for "Checking the Components of the Electronic
Ignition System."
4) Begin with burner 1, furthest to the left. Put match
in the matchstick holder and strike match. Insert lit
match down through the cooking grates, past the
FLAVORIZER BARS and next to the burner (A).
5) Push the burner control knob in and turn it anti-
clockwise to the start/high position.
6) Check that the burner is lit by looking through the
cooking grates and through the FLAVORIZER BARS (B).
7) If the burner does not ignite within 4 seconds,
turn burner control knob to the off
wait five minutes to allow the gas to clear before
attempting to light the burner again. If repeated
attempts fail, follow the gas flow troubleshooting
instructions on the next page.
8) If the burner ignites, the problem lies in the ignition
system. Follow the instructions for "Checking the
Components of the Electronic Ignition System".
9) After burner 1 ignites, you can turn on burner 2
(and burner 3).
A
B
position and