AT3108U Demo board quick start guide
3
Building and running project
Running the AT GUI program makes it easier to start the Touch Demo Board. Follow the steps below
to start the Demo Board:
Step 1.
Prepare the I2C to UART Board and Touch Demo Board.
Step 2.
Set up the I2C to UART Board and Touch Demo Board.
Step 3.
Connect the I2C to UART Board to your PC.
Step 4.
Run the AT GUI program.
3.1
Prepare the I2C to UART Board and Touch Demo Board
3.1.1
Hardware components of the I2C to UART Board
1.
The I2C to UART Board operates as an I2C Master based on the Touch Demo Board, and
contacts your PC through UART communication.
2.
The I2C to UART Board is connected to the USB port on your PC, and can be tested using
the GUI program.
Figure 6. I2C to UART Board Layout
3. Building and running project
9