Advertisement
MONITOR CONTROLS – FRONT PANEL
1
1) Volume Control- Turn the dial to adjust the volume
2) TV/Monitor Switch – Allows you to switch from TV mode to live camera video
3) UHF/VHF-H/VHF-L Switch – You can switch between 3 selectable TV Bands when the monitor is set
3) Select TV Band – Turn to` select the following TV channels (air)
(a) UHF – Channels 14 to 83
(b) VHF-H – Channels 7 to 13
(c) VHF-L – Channels 2 to 6
4) Auto/C1/C2 Indicator light
Auto – The green light will illuminate when set to AUTO
C1- The green light will illuminate when set for Channel 1
C2- The green light will illuminate when set for Channel 2
5) Auto/C1/C2 Switch
Auto – Allows you to sequence between camera 1 and 2
C1 - Allows you to see Camera 1
C2 – Allows you to see Camera 2
6) Power Indicator Light - A red indicator light indicates that the system is ON
7) Tuning Control – By turning this tuning control you can select the following TV channels (air)
(a) UHF – Channels 14 to 83
(b) VHF-H – Channels 7 to 13
(c) VHF-L – Channels 2 to 6
Note: An optional battery compartment is located at the bottom of the monitor. It requires 10 "C" cell
alkaline batteries to power the monitor
2
3
to TV (Band selection depends on the channel you are looking for)
4
3
5
6
7
Advertisement
