Page 2
The motorized controls have the ability to give you a viewing angle of 330° horizontal, and 90° vertical. This dome camera can connect to any Lorex Color Observation System or DVR with a 6-pin DIN or BNC / RJ-485 Connection supporting the PELCO-D Protocol.
In order to improve the feature functions and quality of this product, the specifications are subject to change without notice from time to time. LOREX TECHNOLOGY INC. http://www.lorexcctv.com General Precautions...
Table of Contents Table of Contents Camera Features ... 4 Getting Started ... 5 Camera Connections – DIN Cable ... 6 DIN – Port Pins... 6 Camera Connections – DIN to BNC / RS-485 Adaptor Cable ... 7 Observation System / DVR Connections ... 7 Observation System / DVR Connections (cont.) ...
Getting Started Getting Started The system comes with the following components: 1 x MINI COLOR PAN / TILT 1 x 65’ DIN EXTENSION DOME CAMERA CABLE 1 x MOUNTING BRACKET 1 x DIN TO BNC / RS-485 ADAPTOR CABLE 1 x POWER ADAPTOR FOR 1 x HARDWARE MANUAL DIN TO BNC ADAPTOR CHECK YOUR PACKAGE TO CONFIRM THAT YOU HAVE RECEIVED THE COMPLETE...
Camera Connections – DIN Cable Camera Connections – DIN Cable NOTE: Visit us on the web at http://www.lorexcctv.com Before installation make sure that: • You have the proper lift equipment or ladder to reach the installation location. • Electrical power is not connected to the dome camera and surveillance monitor during installation. DIN Installation NOTE: The camera will only work on CHANNEL 1 when using the DIN Cable connection.
Camera Connections – DIN to BNC / RS-485 Adaptor Cable NOTE: The camera will work on a BNC channel when using the Adaptor Cable. Please refer to the Observation System User manual for details on available channels for PTZ functionality. 1.) Connect the 65 ft Din cable (included with the dome camera) to the wired lead of the dome camera.
Observation System / DVR Connections (cont.) Observation System / DVR Connections (cont.) Connecting to RS-485 (PTZ): Connections: White: RS-485 + Black: RS-485 - Note: Additional settings are required on the Observation System (to control the PTZ). Please refer to the Observation System Hardware Manual for menu details Connecting to BNC: Connectivity Diagram Camera...
Changing the Camera Address Settings NOTE: This is only applicable when using the BNC Adaptor cable. CH1 is the only available channel if using the DIN Connection. The DIP switches inside the camera can be changed to set a unique address for the Camera (set to 1 by default).
Changing the Camera Address Settings DIP Switch Address Chart (cont’d.) Calculating the DIP Switch Addresses Each switch in the block has a specific associated value. When the switch is turned ON, the value is added to the total. Switch # Value Ex.
Housings Connections Dimensions As our products are subject to continuous improvement, LOREX Technology Inc. and its subsidiaries reserve the right to modify product design, specifications and prices, without notice and without 1/3” Interline Transfer Color CCD 768K (H) x 494K (V) 525 Lines, 2:1 Interlace 15.734 KHz (H) x 59.94Hz (V)
Page 12
It’s all on the web Product Information User Manuals Quick Start Guides VISIT www.lorexcctv.com Lorex Technology Inc. Specification Sheets Software Upgrades Firmware Upgrades www.lorexcctv.com...