Mercedes-Benz M-Class Owner's Manual page 307

Stowage areas
304
Inserting the brackets into the loading
rail
Insert bracket : into the centre of loading
X
rail ?.
Press release button ; and push
X
bracket : into the desired position in load-
ing rail ?.
Let go of release button ;.
X
Press locking button =.
X
Bracket : is locked in loading rail ?.
If necessary, fold lashing eyelet A
X
upwards.
G
WARNING
Distribute the load on the lashing eyelets
evenly.
Otherwise, vehicle occupants could be
injured by objects being thrown around if you:
brake sharply
R
change direction suddenly
R
are involved in an accident
R
Please observe the loading guidelines.
Luggage holder
The luggage holder can be used to secure
light loads against the side wall of the luggage
compartment to prevent them from moving
around.
! Only use the luggage holder to secure
loads with a maximum weight of 7 kg and
with dimensions that the luggage holder
can safely and securely contain.
To install: insert two brackets A into the
X
left or right loading rail (
Press release button : of the luggage
X
holder and pull the strap out slightly.
Insert luggage holder ; into brackets A
X
and, while doing so, press release button
= and push the luggage holder downwards
until it engages.
Press release button : of the luggage
X
holder and pull the strap out in the direction
of the arrow.
Place the load between the strap and the
X
luggage compartment side wall.
Using one hand, press locking button : of
X
the luggage holder.
With your other hand, let the strap go slowly
X
until the load is secured.
Make sure that locking button ? on brack-
X
ets A is pressed.
This keeps brackets A in place on the
loading rail.
To remove: press release button = on
X
respective bracket A and remove luggage
holder ; by pulling upwards and out.
Telescopic rod
The telescopic rod can be used to secure the
load against the rear seats to prevent it from
moving around.
page 303).
Y