CeraGem MASTER V4 User Manual page 18

* In semi-automatic mode, the internal projector will not move to the cervical spine after the
mode ends.
3. Using the remote control
Using semi-automatic mode
1. Turn on the remote control, check the current status
and press the semi-automatic mode button.
2. Specify the target area for massage by holding down
either the up/down buttons until the desired position
is found.
3. The semi-automatic mode will begin at the chosen
location. Remain in the proper body postion.
- The remaining time is displayed at the upper left corner of the screen.
If the remote control is operated while in use, the remaining time is reset.
- When 60 minutes have passed after operating the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order
to prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off
automatically.
32
Duration for mode Approximately 60 minutes.
* In semi-automatic master mode, the internal projector will not move to the cervical spine after
the mode ends.
3. Using the remote control
Using semi-automatic (master) mode
1. Turn on the remote control, check the current status
and press the semi-automatic mode button twice.
2. Move the internal projector to the desired position
using the up/down button.
- The selected position will be displayed in green.
Position
Neck area (cervical spine)
Back area (thoracic vertebrae)
Waist area (lumbar vertebrae)
3. Once scanning is complete, the semi-automatic master
mode will begin. Remain in the proper body position.
- The remaining time is displayed at the upper left corner of the screen.
If the remote control is operated while in use, the remaining time is reset.
- When 60 minutes have passed after operating the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order
to prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off
automatically.
Duration for mode Approximately 60 minutes.
Screen display (24 segments)
C1~7
T1~12
L1~5
33