Warnings and safety information This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Page 3
Warnings and safety information Warnings and safety information Warning - Consult your doctor prior to use if you have any external wound(s) or infection(s) on the skin where the product will come into direct contact with your skin. 1. Only use the product if it is in mechanically complete condition. - Immediately stop using the unit if you start to feel sick or uncomfortable, or if the If damaged products are used, there is a possibility of injury or burns.) massage seems too painful.
Warnings and safety information Warnings and safety information 13. The appliance has a heated surface. Persons insensitive to heat must be careful when using the appliance. 14. Please take care not to spill any foreign substance in between the main equipment and the ※...
Page 5
>> Warnings and safety information - Danger - Warning Ⅰ. Introduction - Caution to the Master V4 Ⅰ. Introduction to the Master V4 1. Indications for use 2. Product features 1. Indications for use 3. Parts and components 2. Product features Ⅱ.
1. Indications for use 3. Parts and components The intended use of the Ceragem Automatic Thermal Massager. * Design (color) and the cover pattern may vary according to the product. Model CGM MB-1901 is to provide muscle relaxation therapy by delivering heat and soothing massage.
1. Check product components 2. Before installation 3-sphere projector Easy to use on body parts such as the abdomen, shoulders, arms, legs and etc. Can be used with the main product or shared between two people. Install/assemble on a solid, level surface to avoid damage to the product. Abdominal vibration projector This can be connected to the main body and used on the abdomen.
3. Installation 4. After installation * Please refer to the included assembly guide. Turn on the power at the side of the main body. (Please turn off the main power switch when the product is not in use.) Take out the product and its components from the box. 모델명...
Wait! Ⅲ. Using Before using the product, check if the remote control and external projectors are connected correctly. the Master V4 (An image is displayed on the remote control only when external projectors are connected.) ② 1. Before using the product Connect the remote control to the main body.
2. To cycle through the heating elements and select the desired item, repeatedly click the temperature select button, 2. The Ceragem logo will appear on the screen of the until the item you'd like to adjust is highlighted in red.
3. Using the remote control 3. Using the remote control Setting the intensity Setting the thermal sofa mode (supporting mat closed) 1. When the supporting mat is closed, the device can 1. Check the current strength and press the strength be operated as a thermal sofa for comfortable seating.
Page 14
- Voice guidance will halt if the sound is paused or the volume is set to level 0. only when the setting is selected. When any external sound source is connected Voice guidance is activated Ceragem Sound → USB → Bluetooth → (deactivated) 3. Check the changed sound status on the screen of the 3.
Page 15
3. Using the remote control 3. Using the remote control Using abdominal vibration projector mode Adjusting abdominal vibration projector strength 1. Check if the abdominal vibration projector is 1. Check the screen of the remote control. connected correctly. - If properly connected and recognized, the icon will be displayed. - If properly connected and recognized, the icon will be displayed.
Page 16
Automatic mode button then toggling between the up/down button while the mode display is highlighted in yellow. - When the mode begins, the Ceragem sound will commence. (A sound source will not be played back while using the meditation mode.) - The mode cannot be paused during scanning.
3. Using the remote control 3. Using the remote control Using manual mode Using manual (master) mode Duration for mode Approximately 60 minutes. Duration for mode Approximately 60 minutes. 1. Turn on the remote control, check the current status 1. Turn on the remote control, check the current status and press the manual mode button.
Page 18
* In semi-automatic mode, the internal projector will not move to the cervical spine after the * In semi-automatic master mode, the internal projector will not move to the cervical spine after mode ends. the mode ends. 3. Using the remote control 3.
3. Using the remote control 4. Moving the product Changing a product number Disconnect the power cord, remote control, and external projector from the main body. Close the supporting mat and shift the head cushion back into place. * If there are two or more products in one space, the device number can be changed as required for use of the product. (To open the supporting mat, pull forward and then lower it.) * Devices can be identified and selected by number when connected via bluetooth.
MEMO Ⅳ. Maintenance and troubleshooting 1. User Checklist (Before & After use procedure) 2. Maintenance and storage 3. Troubleshooting 4. Diagnostic codes 5. Product specifications...
1. User checklist (Before & After use procedure) 2. Maintenance and storage Checklist (Before use) Exterior of the product is a petroleum-based product and should not be exposed to organic solvents such as acetone, ballpoint pen, gasoline, thinner, 1. Is the power cord connected to the socket? sweat, hair mousse or hair spray.
Q : Is a sound source in a USB device not playing back? A : It takes time for the product to recognize a USB device. Check if it is connected correctly, Notify Ceragem and the relevant organization (agency) in case of injury, wait, and try again.
Weight 163lbs(± 6lbs) (Including box) Manufacturer CERAGEM Co., Ltd. * This product is a medical device. * Please be advised that since this product was manufactured for domestic use, no after-service will be available when used abroad. * Due to constant quality improvement, design and specifications of the product are subject to change without notice.
CLASS II EQUIPMENT Degree of electric shock protection TYPE BF APPLIED PART. The Model CGM MB-1901(CERAGEM CO., LTD. Automatic Thermal Massager)is intended for use Degree of protection from harmful invasion of water Ordinary in the electromagnetic environment specified below.The customer or the user of CGM MB-1901 should assure that it is used in such an environment.
2. Attached documents 2. Attached documents Manufacturer’s declaration - electromagnetic immunity The CGM MB-1901 is intended for use in the electromagnetic environment specified below. The CGM MB-1901 is intended for use in the electromagnetic environment specified below. The customer or the user of CGM MB-1901 should assure that it is used is such an environment. The customer or the user of CGM MB-1901 should assure that it is used is such an environment.
Page 26
2. Attached documents 2. Attached documents Manufacturer’s declaration - electromagnetic immunity Recommended separation distances between portable and mobile RF communications The CGM MB-1901 is intended for use in the electromagnetic environment specified below. equipment and the CGM MB-1901. The customer or the user of CGM MB-1901 should assure that it is used is such an environment. The CGM MB-1901 is intended for use in an electromagnetic environment in which radiated IEC 60601 Electromagnetic...