CeraGem MASTER V4 User Manual page 16

3. Using the remote control
Using automatic mode
1. Turn on the remote control, check the current status
and press the automatic mode button.
Mode A (Standard) :
Mode 1 (Special) : Approximately 75 minutes
Mode 2 (Relax) : Approximately 18 minutes
Mode 3 (Stable)
Mode 4 (Circulation) : Approximately 36 minutes and 30 seconds.
Mode 5 (Basic health) : Approximately 36 minutes and 30 seconds.
Mode 6 (Energy) : Approximately 36 minutes and 30 seconds.
Mode 7 (Study) : Approximately 36 minutes and 30 seconds.
Mode 8 (Sleep) : Approximately 36 minutes and 30 seconds.
Mode 9 (Body line) : Approximately 36 minutes and 30 seconds.
Mode 10 (Meditation 1) : Approximately 18 minutes
Mode 11 (Meditation 2) : Approximately 36 minutes and 30 seconds.
2. Cycle through the modes by repeatedly pressing the
automatic mode button until the desire massage
program is chosen. Scanning will begin. Remain in
A
the proper body position--supine and relaxed, lying on
your back, legs outstretched.
- Massage mode can be chosen either by repeatedly pressing the Automatic
mode button or by selecting the Automatic mode button then toggling
between the up/down button while the mode display is highlighted in yellow.
- When the mode begins, the Ceragem sound will commence.
(A sound source will not be played back while using the meditation mode.)
- The mode cannot be paused during scanning.
- The body type graph varies from person to person.
3. Once scanning is completed, the massage program
will start. Please remain in the proper position.
- The time remaining will be displayed at the top of the human body icon.
- When pausing, the internal projector will move down vertically in order
to prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off
automatically.
28
Approximately 36 minutes and 30 seconds.
Approximately 36 minutes and 30 seconds.
:
Sequential press (Mode A, 1~11 are selected sequentially)
3. Using the remote control
Using intensive mode
1. Turn on the remote control, check the current status
and press the intensive mode button.
2. When scanning is completed, the intensive mode
will begin. Maintain proper body position.
- The time remaining will be displayed at the top of the human body icon.
- If the remote control is operated while using the product, the time
remaining will be displayed.
3. To specify the area for intense massage, move the
internal projector by holding down on the up/down
button until the location is found.
- If you cancel the position setting by pressing the intensive mode
button again, the internal projector will move.
- When 90 minutes have passed after setting the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order
to prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off
automatically.
Duration for mode Approximately 90 minutes.
29