Technical Data; Installation - Zanussi ZFU216FWO User Manual

If the malfunction shows again, contact the Service
Centre.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to the
rating plate.

Technical Data

For further technical information please refer to the
rating on the internal left side of the appliance and in
the energy label.

Installation

Read the Safety information carefully for your
safety and correct operation of the appliance
before installation.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate Class
SN
N
ST
T
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely around
the back of the cabinet. To ensure best performance,
if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top
of the cabinet and the wall unit must be as least
100 mm. Ideally, however, the appliance should not
be positioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable feet at
the base of the cabinet.
14
Ambient Temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Model description
(Mod.) ....................................................
Product number
(PNC) ....................................................
Serial number
(S.N.) ....................................................
Dimensions
Height
Width
Depth
Rising Time
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply. The appliance must be
earthed. The power supply cable plug is provided
with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed. This
appliance complies with the E.E.C. Directives.
Rear spacer
In order to ensure the required space behind the
appliances for ventilation, please make sure the rear
spacer bracket is installed before switching on the
appliance. Below is the installation sequence for the
rear spacer:
1. Press the spacing bracket on both sides with your
fingers.
1440 mm
554 mm
570 mm
10 hours