What To Do If - Zanussi ZFU216FWO User Manual

Defrosting of the freezer
The compartment of this appliance is "no frost". This
means that there is no buildup of frost when it is
running, neither on the internal walls nor on the foods.
The absence of frost is due to the continuous
circulation of cold air inside the compartment, driven
by an automatically controlled fan.

What to do if...

Warning! Before troubleshooting, disconnect the
power supply. Only a qualified electrician or
competent person must do the troubleshooting that is
not in this manual.
Problem
Appliance does not work.
Appliance freezes too much.
The food is not frozen
enough.
Heavy build-up of frost on
the door seal.
Unusual noises.
Possible cause
Appliance is not switched on.
Mains plug is not plugged in or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold or the appliance is
running in Super Freeze mode.
Temperature is not properly adjusted.
Door was open for an extended period.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
The appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall or other
objects.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Turn the temperature regulator to a warmer
setting temporarily or press the "Super
freeze" button to stop Super freeze mode.
Please look in the initial Control Panel
section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a cool
setting). At the same time shape the
warmed door seal by hand so that it sits
correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component
out of the way.
Solution
13