Enable Telnet User Login Access; Restoring Factory Defaults; Voice Connection; Battery Backup Connection - ADTRAN Total Access 900E Series Quick Start

should send all of its traffic. You will need to enter the proper route, subnet mask, and gateway for your
network. This information is typically provided by a service provider or local network administrator.
7. Enter do write memory to save the current configuration.
E T
NABLE ELNET
The following steps enable user login parameters for Telnet access by changing the password from the default
(password) and enabling security login on Telnet lines.
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet sessions.
3. Enter login to prompt users with a login prompt for Telnet access.
4. Enter password adtran to change the login password for the Telnet sessions.
5. Enter exit to return to the Global Configuration mode.
6. Verify that the prompt of your unit displays (config)#.
7. Enter do write memory to save the current configuration.
T A
OTAL CCESS
Feature
IP Address
DHCP
Auto-Config
Username
Password
HTTP Server
Event History
IP Routing
R F
ESTORING
On units that have a console port, you cannot restore the factory defaults, but must rather erase the device's
configuration and then reconfigure the unit to operate correctly for your network. To erase the unit's current
configuration, follow these steps:
1. Access the unit's CLI and enter enable at the > prompt.
2. Enter erase startup-config at the # prompt. The device will have a blank configuration upon reboot.
3. Enter reload at the # prompt to begin restarting the device. When prompted to save configuration, enter
no. When prompted to reboot, enter yes.
Upon reboot, you will have to reconfigure the unit using the port labeled CRAFT. Follow the steps outlined here
or in the technical note,
forums.adtran.com.
V C
OICE ONNECTION
A single 50-pin female amphenol connector provides the interconnect wiring for the analog circuits (FXS). Refer
to the Total Access 900 Series Hardware Installation Guide
forums.adtran.com for detailed pinouts.
B B
ATTERY ACKUP
An optional battery backup system (P/N 1175044L1/L2) is available for the Total Access 912/916/924. Refer to
the Total Access 900 Series Hardware Installation Guide
and the documentation shipped with the battery backup system for more information on this connection.
64243916F1-13C
U L
SER OGIN
900E S
ERIES
D
ACTORY EFAULTS
Accessing the Web Interface in AOS,
C
ONNECTION
A
CCESS
D
EFAULTS
Default Value
10.10.10.1
Client Enabled
Zero Touch Provisioning Enabled
admin
password
Enabled
On
Enabled
available online at
available online at
available online at
https://support-
https://support-
https://supportforums.adtran.com
3