Maintaining The Alphatrak 3 Meter; Replacing The Battery - Zoetis AlphaTrak 3 User Manual

Maintaining the AlphaTrak 3 Meter

Replacing the Battery

(Picture)
(Picture)
(Picture)
6. Set sound:
 Press c to select your preferred sound setting for this alarm (low beep, louder beep, no sound)
 Press m to save
7. Press and hold m for 3 sec to turn off the meter.
The meter comes with two CR 2032 3 V lithium batteries installed.
When appears on the display, the battery is low.
• When this appears, the meter may fail to turn on.
• When you are ready to install a new battery, remove the old battery and install the new battery
within 60 seconds to avoid losing time and date settings.
• If time and date settings are lost, both time and date will flash until reset. If the time and date
settings are lost, you may still perform an accurate blood glucose test.
• Memory log and previously stored user settings, such as date and time format, are not affected by
removing the battery.
1. Slide the battery door to the right to open.
2. To remove the batteries, pull the plastic tab up to release the batteries.
3. Insert two new batteries: (+) facing up.
4. To close, slide the battery door in until it snaps into place.
Note: The battery in this product should be removed and disposed in accordance
with local regulations for separate collection of electronic waste and spent batteries.
27