Installation and setting
Fig. 6
Check the turn plate
•
Push one of the turn plate buttons. The buttons must be lit when the turn plate is
activated.
•
Check that the unit can rotate around the turn plate, see Fig. 6.
•
Push the turn plate button again and check that the turn plate goes back in parking
position.
•
Repeat the check with the other turn plate button. If any problem occurs, see "Service
Instructions, section Adjustment and replacement of the turn plate".
Check the brake
•
Lock the brake. It should not be possible to move the MOBILETT with normal hand effort.
A slight skip is acceptable when using a force, greater than 350N.
Siemens-Elema AB
Solna, Sweden
Fig. 7
SPR8-220.033.03
Rev. 02
10.02
Page 9 of 12
MOBILETT Plus HP
SPS-UD
2 - 9
2
2