Table of Contents
Advertisement
Operation
Command Summary
Table 3.7 Calibration Commands
Command
CMODE
IDATA
IHI
ILO
IRDAT
IRHI
IRLO
OVCAL
VDATA
VHI
VLO
VRDAT
VRHI
VRLO
Table 3.8 Status Commands
Command
ASTS?
FAULT?
MASK
STS?
UNMASK
UNMASK?
38
Description
Places the supply into calibration mode.
Calculates the slope and intercept for current programming.
Sets the current output to the high calibration point.
Sets the current output to the low calibration point.
Calculates the slope and intercept for current readback.
Sets the current output to the high readback point.
Sets the current output to the low readback point.
Calibrates the over voltage protection (OVP).
Calculates the slope and intercept for voltage programming.
Sets the voltage output to the high calibration point.
Sets the voltage output to the low calibration point.
Calculates the slope and intercept for voltage readback.
Sets the voltage output to the high readback point.
Sets the voltage output to the low readback point.
Description
Asks for the supply's accumulated status register.
Asks for the supply's fault register for the status preset operating
conditions.
Prevents the supply's previously unmasked operating conditions from
setting bits in the fault register.
Asks for the supply's present status register.
Enables you to select those supply's operating conditions that you are
most interested in monitoring for fault occurrence.
Asks for the supply's fault conditions which are currently enabled
(unmasked).
Operating Manual for GPIB for XHR/XFR Series Power Supply
Advertisement
Table of Contents
