Table of Contents
Advertisement
Command Syntax
Manual
The manual uses these conventions when displaying command information. These
Conventions
characters are not part of the command but are used to denote parameters used with
the command.
< > (angle brackets)
/ (slash)
COMPUTER ENTRY
Command
The device-dependent language for the GPIB Interface consists of commands and
Format and
parameters. A command is a one word code which either gives instructions to the
interface or asks for information from the interface. A command may be followed by
Parameters
one or more parameters, a short code that changes the state of the power supply or
the state of the bit register. Table 3.3, "Command Parameters" lists the parameters
that affect the command set.
Format:
•
•
•
COMMAND or
COMMAND <parameter> or
COMMAND <parameter>,<parameter>
You can enter commands in upper or lower case lettering.
Example:
MASK FOLD = mask fold
Do not further abbreviate command names or parameters.
MASK FOLD ≠ MK FOLD
Example:
MASK FOLD ≠ MASK FD
Use a space between the command and the first parameter. Any number of
consecutive spaces is treated as one space. Numeric data may contain leading
spaces. Embedded spaces between digits or between a digit and a decimal point
are not accepted.
Example:
MASK FOLD = MASK
VOUT 3.4 = VOUT
VOUT 3.4 ≠ VOUT 3. 4
Angle brackets enclose a parameter. Do not include
the angle brackets in the command line you send to
the computer.
Separates two alternative parameters. When a slash
separates two parameters, you can use either
parameter to achieve the same result.
Example:
<1/ON>
Entering
or
will achieve the same result.
1
ON
Words typed on the computer are shown in Arial
text, full capitals.
FOLD
3.4
Operation
Command Syntax
33
Advertisement
Table of Contents
