Table of Contents
Advertisement
logger is not responding (actually the logger is waking up but can't talk properly yet). Then it may
say "Finding" and then "Connecting..." and then "Found SN0123". PmScreen will come up with
its initial screen if the logger is being turned on (or whatever the screen state is on the logger if you
have been using it) and at that point you are now in contact with the logger.
PM7000 initial
screen as seen on
the PDA
Now with your PDA in your hand you can play around and explore all the options that are available
to you within your PM7000.
[On the other hand before you go any further you may wish to explore the PM7000 menu interface
in some detail without involving the logger. You can do this is via a PmScreens Simulator which
will come up on your computer screen. Find it on the customer CD under PmStart or within the
Pronto software programme. How to open and use the simulator is explained below.]
When you have finished with the PDA, IT IS IMPORTANT to release the Bluetooth
communication on it or the PDA gets stuck. Do this by leaving Pmscreen by pressing "File"/"Exit"
on the PDA. You should do this BEFORE you go out of range.
(In PDA's supplied earlier DO NOT press the "X" in the top right hand corner as this doesn't turn
off PmScreen or the Bluetooth, it merely hides them.)
To turn off the PDA (having exited PMScreens), press the off button on the PDA itself. (Generally
top right).
PM7000 Start Guide Issue 1 090608
10
Advertisement
Table of Contents
