Maytag 4KMVWC410JW1 Use And Care Manual page 18

TROUBLESHOOTING
If you experience
Washer Not Performing As Expected (cont.)
Odors
Lid Locked light
is flashing
Single-dose laundry
packet not dissolving
Washer pumps out water
before finishing cycle
EU representative: Whirlpool EMEA S.p.A., Via Carlo Pisacane n. 1, 20016 Pero (MI), Italy.
Manufacturer: Whirlpool Corporation, 2000 N M 63, Benton Harbor, MI 49022 USA.
For more information, visit us at www.whirlpool.sa or contact the dealer from whom you purchased your washer or a Whirlpool authorized
service company.
First try the solutions suggested here to possibly avoid the cost of a service call.
Possible Causes
Monthly maintenance not done
as recommended.
Using too much detergent.
The lid is not closed.
A cycle was stopped or paused using
the Start/Pause/Cancel button.
Adding laundry packet incorrectly.
Lid is left open for more than
10 minutes.
See "Washer Care" in Washer Maintenance.
Unload washer as soon as cycle is complete.
Be sure to measure correctly. Always follow the
manufacturer's directions.
See "Washer Care" section.
Close the lid. The washer will not start or fill with the lid open.
The washer may still be spinning. The lid will not unlock until the
basket has stopped spinning. This may take several minutes if
washing large loads or heavy fabrics.
Be sure laundry packet is added to washer basket before adding
clothes. Do not add packet to dispenser. Follow the manufacturer's
instructions to avoid damage to your garments.
Make sure lid is closed before starting a cycle and/or during
prewash (soak).
Solution