Fpl3 Flash Programming Software; Introduction; Starting Up The Gui Software; Figure 35: Gui Software Main Window - NEC 78K0/Fx2 User Manual

78K0/Fx2 – CAN it!

9. FPL3 FLASH programming software

9.1 Introduction

The parameter file for the 78K0/FF2 device is installed automatically during installation of FPL3
GUI, folder <FPL3 install-path>\PRM. Nevertheless, newest version of parameter file for the
μPD78F0893 device can by download from the NEC Electronics Web site.
Download the parameter file for the PG-FP4 from the following NEC Electronics Web site:
Copy the parameter file downloaded from the NEC Electronics Web site into sub-directory
<FPL3.EXE-install-path>\PRM created during GUI software setup (refer to CHAPTER 8
SOFTWARE INSTALLATION)..

9.2 Starting up the GUI Software

•
GUI software startup
Select FPL3.EXE from the start menu to start the FPL3 GUI software.
When the GUI software is started normally, the following screen appears.
Menu bar
Toolbar
Action log window
Status bar
http://www.eu.necel.com/updates

Figure 35: GUI Software Main Window

Programmer
parameter
window
45