Power Cord - Campbell Hausfeld PW1345B Assembly Instructions And Parts List

Assembly Instructions and Parts List

Power Cord

1. Plug the power cord into a ground-
ed 120V outlet and press the reset
button as shown in figure 3.
2. THIS MUST BE DONE EACH TIME THE
UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 3 - Grounded plug/reset button
www.chpower.com
! IMPORTANT !
This pressure washer is equipped with
a microswitch sensitive to water flow.
This Instant Start/Stop switch (ISS)
senses water flow in the pump. When
the trigger is released, water stops
flowing through the pump. The ISS
then automatically turns the motor
off to protect pump from overheat-
ing.
OPERATION
1. Turn the "ON/OFF" switch to "ON".
2. Pull trigger on gun to begin spray-
ing water.
3. Release trigger. The pressure wash-
er motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even if trig-
ger is released. This is part of normal
operation and will not damage the
unit.
CAUTION
!
"OFF" then trigger gun to release
hose pressure before unplugging
power cord.
WARNING
!
ing when trigger is squeezed if
on/off switch is in "ON" position.
Always point gun in safe direc-
tion.
Call 1-800-330-0712
for Technical Service
2
PW1345B
Always turn the
"ON/OFF" switch to
Risk of Injection.
Unit will start spray-