Table of Contents
Advertisement
User Manual
1.5
Tool Operation
W A R N I N G
ROTATING SPINDLE
To Avoid Injury:
• Always wear eye and foot protection when operating and when in areas
where power tools are being used.
• Keep all body parts and clothing away from the rotating end of the tool.
Dress properly. Do not wear loose-fitted clothing or jewelry.
TORQUE REACTION FORCE
To Avoid Injury:
• Be alert and maintain good balance, footing, and posture at all times in
anticipation of the tool's torque reaction. Do not over-extend or over-reach.
• Be prepared for the change in direction and or a higher reaction force when
a tool is in reverse.
• The start lever should be positioned to avoid trapping the operator's hand
between the tool and the work piece.
TOOL MAY NOT SHUT OFF
To Avoid Injury:
• If the tool does not shut off at the end of the tightening cycle, contact the
person responsible for tool installation or repair. Note: When the tool does not
shut off, a stall condition occurs. A stall condition can cause a higher than
expected torque reaction impulse.
• Ensure tool is properly installed, adjusted and in good working order.
• Do not use the power tool if the switch does not turn it on and off.
• Apply the tool to the joint following all recommendations in this manual.
• Check to ensure the drive socket is fully seated and locked into position
before connecting power to the tool.
Prepare to resist the tool's torque reaction:
Start the tool by depressing the start lever or trigger.
Release start lever after the cycle is complete.
12
Advertisement
Table of Contents
