Tool Installation - Stanley EB35PB User Manual

QPM DC Electric Tools
1.3

Tool Installation

W A R N I N G
To Avoid Injury:
• Always wear eye and foot protection when installing equipment.
• Only use equipment and accessories specifically designed to operate
with Stanley assembly tools and use them only in the manner for which
they are intended.
• Do not install worn, damaged, or modified equipment that may be
unsuitable for safe use.
• Train all operators in the safe and proper use of power tools.
Operators should report any unsafe condition.
• Store idle tools and accessories in a safe location accessible only by
trained persons.
• Disconnect power source (air, electricity, etc.) from tool prior to making
adjustments, changing accessories, or storing.
• Prior to operation, always check and test tools and accessories for
damage, misalignment, binding or any other condition that may affect
operation. Maintenance and repair should be performed by qualified
personnel.
• Do not operate tools in or near explosive environments or in the
presence of flammable liquids, gases, dust, rain or other wet conditions.
• Keep the work area clean, well lit and uncluttered.
Keep unauthorized personnel out of the work area.
DC Electric Tools & Controllers:
• Install tools in dry, indoor, non-flammable, and non-explosive
environments only – Humidity: 0 to 95% non-condensing and
Temperature: 32 to 122 ºF (0 to +50 ºC).
• Installation, maintenance and programming should be performed by
qualified personnel. Follow all manufacturer installation instructions and
applicable regulatory electrical codes and safety codes.
• Tool and controller plugs must match the outlet. This equipment must
be earth grounded. Never modify a plug in any way or use any adaptor
plugs.
• Avoid body contact with electrically energized surfaces when holding a
grounded tool.
• Prior to connecting a power source, always ensure the tool or
controller is turned off.
• Limit controller access to trained and qualified personnel. Lock
controller cabinets.
7