Tool Status Lights; Setting Torque, Angle, And Other Operating Parameters - Stanley EB35PB User Manual

1.5.4

Tool Status Lights

Handheld tools from STANLEY ASSEMBLY TECHNOLOGIES have three (green,
yellow, and red) status lights. The status light mirror or copy the status lights on
the controller or control panel.
Light Status Description
Green Tightened to The tightening cycle meets all of the
specified limits specified parameters.
Yellow Low torque or The tightening cycle was rejected for not
angle achieving either low torque or low angle.
Red High torque or The tightening cycle was rejected for
angle exceeding either high torque or high angle.
All Reverse The next time the start trigger is engaged
lights the tool will remove the fastener.
1.5.5

Setting Torque, Angle, and Other Operating Parameters

EXCESSIVE TORQUE CONDITION
To Avoid Injury:
• Only trained and qualified personnel should program controllers.
• Never set control limits above the maximum rating of the tool.
• Setting control limits above the maximum rating of the tool can cause
high reaction torque.
• Always test for proper tool operation after programming the controller.
The Alpha controller can be setup to change tightening Jobs or Tasks from the
tool's MFB.
Press, or hold, the MFB to change the operating program on the controller. See
section 1.4.2 for programming the MFB.
Press, or hold, the MFB to return the tool to the previous operating program.
QPM DC Electric Tools
W A R N I N G
15