Weider 150 TC User Manual page 8

6. Apply some of the included grease to an M10 x
85mm Bolt (23). Attach the Backrest Frame (5)
to the Frame (1) with the Bolt and an M10
Locknut (19). Do not overtighten the Locknut;
the Backrest Frame must pivot easily.
Attach the tether on the Locking Pin (21) to the
bottom of the Frame (1) with an M4 x 16mm
Screw (28). Next, insert the Locking Pin into the
Frame and into an adjustment hole in the Pivot
Bracket (6).
Attach an M10 x 20mm Bolt (25) and an M10
Locknut (19) to the hole in the end of the Pivot
Bracket (6).
See step 5. Tighten the M10 Locknuts (19).
7. Orient the Backrest (7) as shown. Attach the
Backrest to the Backrest Frame (5) with four M6
x 16mm Screws (24).
8. Attach the Seat (8) to the Frame (1) with four
M6 x 60mm Screws (17) and four M6 Washers
(22).
9. Make sure that all parts are properly tightened before you use the weight bench.
All manuals and user guides at all-guides.com
8
6
Grease
23
1
21
28
Tether
7
24
5
24
8
1
22
5
19
19
6
25
7
8
22
17