FANATEC DD PRO Manual page 31

AP ( ANALOGUE PADDLES )
5.6.14
AP: CbP; CH; bt; AnA
CbP(Clutch Bite Point): This feature can be used in any game with an
analogue clutch axis. Both left and right analogue paddles work in parallel;
the primary paddle is determined by which is pressed further.
• Press both clutch paddles simultaneously to a least 5% to activate,
move both paddles up to 100%.
• Release one paddle whilst keeping the other fully pressed. The dis-
play will now show the percentage value of the released paddle while
the car's clutch is still fully pressed.
• Set the released paddle to the percentage where your car's clutch
starts to bite (recommended to evaluate by conducting multiple
launch starts).
• As soon as the virtual start lights turn green, completely release one
of the fully pressed paddles and the clutch will immediately be at the
bite point.
• Release the second paddle once a suitable speed is reached for the
optimum launch.
CH(Clutch / Handbrake): Left paddle = Clutch. Right paddle = Handbrake.
bt(Brake / Throttle): Left paddle = Brake. Right paddle = Throttle.
AnA(Mappable Axes): Paddles can be mapped as two additional axes. This
may be shared with the analogue joystick on some steering wheels.
NOTE: Not supported by the included steering wheel. Only available if you
are using a Fanatec steering wheel or add-on shifter paddles featuring
analogue paddles which do not have a dedicated hardware switch for
different analogue paddle modes.
27
Clutch bite point configuration steps
Simplified
Compatibility not endorsed by Sony Interactive Entertainment Inc.
AP default: CbP
Advanced
• Completely press and hold one clutch paddle.
• Press the FunkySwitch D-pad stick down. "100" will be shown
TM
on the display. Rotate the FunkySwitch
percentage of the bite point as desired to suit your car (recommended
to evaluate by conducting multiple launch starts).
• Release the paddles to set and store the desired value. You can have
an individually stored value for each Tuning Menu slot S_1 ... S_5.
• At race start, press both paddles again to activate the bite point mode,
Release one of the paddles and the clutch will immediately be at the
bite point.
• Release the second paddle once a suitable speed is reached for the
optimum launch.
in order to change the
TM