FANATEC DD PRO Manual page 29

FORCE / SPRING / DAMPER EFFECT
5.6.10
FOR range: OFF
SPR range: OFF
DPR range: OFF
These FFB modifiers allow you to change the FFB signals of a game (only
applicable if games support these effects). Theoretically, there are three
signal types which a game can send. Force (forces the steering wheel in a
specific direction). Spring (pulls the steering wheel towards the dynamic
centre). Damper (creates friction)
NOTE: Not every game uses all three types of effects and some games use
only one type to create all three effects.
IMPORTANT:
will not be able to move the attached steering wheel to the correct centre
position after a centre calibration is performed. Only adjust these values
higher than 100% if the FFB effects are not strong enough and weaker in
comparison to other games. Raising one or more of these values may result
in higher load on the motor and increase heat generation.
BLI ( BRAKE LEVEL INDICATOR )
5.6.11
BLI range: 001 ... 100
Values from 001 to 100 sets the activation point for brake pedal vibration
(only available when ClubSport Pedals V3 / V3i is connected). This feature
works independently and therefore can be used with any game. It is useful
for learning threshold braking technique. OFF allows pedal vibration to be
controlled by a game directly (if supported).
25
010 ... 120
010 ... 120
010 ... 120
If Spring is adjusted to low values or OFF, the wheel base
OFF
FOR default: 100
SPR default: 100
DPR default: 100
BLI default: OFF