Removing The Engine Guard - Husqvarna FE 450 2021 Owner's Manual

12.45

Removing the engine guard

SERVICE WORK ON THE CHASSIS 12
–
Move the hydraulic clutch fluid reservoir mounted on the han-
dlebar into a horizontal position.
–
Remove screws
–
Take off cover
H03713-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove the protection cap and bleeder
5
screw and mount bleeding syringe
F02352-10
–
Now press the fluid into the system until it emerges from
6
hole of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
H03715-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
–
Remove screws
H01655-01
1
.
2 3
with membrane .
4
with the appropriate hydraulic fluid.
p. 155)
4
.
4 mm (0.16 in)
1
and engine guard.
89