CPI Canada Inc
CLEANING
Millenia / Indico 100 Series Operator Manual
•
Never use anything other than soap and water to clean plastic surfaces. Other
cleaners may damage the plastic.
•
Never use any corrosive, solvent or abrasive detergents or polishes.
•
Ensure that no water or other liquid can enter any equipment. This precaution
prevents short circuits and corrosion forming on components.
•
Methods of disinfection used must conform to legal regulations and guidelines
regarding disinfection and explosion protection.
•
If disinfectants are used which form explosive mixtures of gases, these gases must
have evaporated before switching on the equipment again.
•
Disinfection by spraying is not recommended because the disinfectant may enter the
X-ray equipment.
•
If room disinfection is done with an atomizer, it is recommended that the equipment
be switched OFF, allowed to cool down and covered with a plastic sheet. When the
disinfectant mist has subsided, the plastic sheet may be removed and the equipment
be disinfected by wiping.
#740811-00
Rev. H
Maintenance Schedule
Page 53
8