Brother MFC-J1010DW Online User's Manual page 188

Home > Fax > Receive a Fax
Remote Retrieval Commands
Related Models: MFC-J1170DW
Use the Remote Commands in this table to access fax commands and options when you are away from your
machine. When you call the machine and enter your remote access code (three digits followed by *), the system
will sound two short beeps and you must enter a Remote Command (column 1), followed by one of the options
(column 2) for that command.
Remote Options
commands
95 Change the Fax Forwarding, or Fax Storage
settings
1 OFF
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from memory
97 Check the receiving status
1 Fax
98 Change the Receive Mode
1 External TAD
2 Fax/Tel
3 Fax Only
90 Exit
Related Information
• Remote Fax Retrieval
> Remote Fax Retrieval > Remote Retrieval Commands
Operation details
You can select Off after you retrieve or erase all your
messages.
One long beep means the change is accepted. If
you hear three short beeps, you cannot make a
change because something has not been set up (for
example, a Fax Forwarding number has not been
registered). You can register your Fax Forwarding
number by entering 4. After you register the number,
Fax Forwarding will work.
Enter the fax number of a remote fax machine to
receive stored fax messages.
If you hear one long beep, fax messages have been
erased from memory.
Check whether your machine has received any
faxes. If yes, you will hear one long beep. If not, you
will hear three short beeps.
One long beep means the change has been
accepted.
Press 9 0 to stop remote retrieval. Wait for the long
beep, then hang up.
182