Table of Contents
Advertisement
Flat Par TW5
Default Running Mode:
This is a default running mode. When this mode is activated, all modes will return to their default set-
tings.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
ADJ LED RC3:
This function is used to activate or deactivate the ADJ LED RC3 (Remote Control). When this func-
tion is activated, the fixture can be controlled using the ADJ LED RC3. Please see the ADJ LED RC3
Operation section of this manual for ADJ LED RC3 controls and functions.
1. Press the MODE button until "dXX" is displayed. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "IrXX" is displayed. "XX" represents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
DMX State:
This setting defines the behavior of the fixture in the event that the DMX signal is lost or interrupted.
It also determines the mode that the fixture will default to when it is powered on.
1. Press the MODE button until the DMX address is displayed.
2. Press the SET UP button until "No-X" is displayed. "X" represents a number between 0-2.
3. Use the UP or DOWN buttons to select the operating mode you would like the unit to start up in
when power is applied or the DMX signal is lost.
•
"N0-0" (BLACKOUT) - If the DMX signal is lost or power is applied, the unit will automatically
go into stand by mode.
•
"N0-1" (HOLD) - If the DMX signal is lost, the fixture will stay in the last DMX set up. If power
is applied and this mode is set, the unit will automatically go into the last DMX set up.
•
"N0-2" (FADE PROGRAM) - If the DMX signal is lost or power is applied, the unit will auto-
matically run the fade program.
Dimmer Curve:
This is used to set the dimmer curve used with DMX mode. See the Dimmer Curve Chart section of
this manual for more information.
1. Plug the fixture in and press the MODE button until the DMX address is displayed.
2. Press the ENTER button until "dr-X" is displayed. "X" represents the current dimming mode.
3. Use the UP and DOWN buttons to find your desired dimmer curve. Press SET UP when you are
finished.
•
dr-0 - Standard
•
dr-1 - Stage
•
dr-2 - TV
•
dr-3 - Architectural
•
dr-4 - Theater
ADJ Products, LLC - www.adj.com - Flat Par TW5 User Manual Page 10
Operating Instructions
Advertisement
Table of Contents
