Function; Connection Lead; Connector Pin Assignment; Valance Plus (Mvled Only) - weinor BiLine Combio-868 MVLED Assembly And Installation Instructions Manual

BiLine Combio-868 MVLED/ MLED
3.2

Function

3.2.1

Connection lead

The MVLED/MLED remote-receiver can be fitted to any connection that has its own connector.
The receiver has connection leads for the awning, valance (MVLED only), light and mains
supply. The remote-receiver is supplied pre-fitted to the awning and with all the cables ready-
connected.
3.2.2

Connector pin assignment

The following connector pin assignment is used (see Fig. 1 for details):
•
2-pole AMP male connector, 230 V
•
2 flat plugs, 2.8x0.8, male/female: light LED
•
4-pole AMP female connector: motors for awning and Valance Plus
3.2.3

Valance Plus (MVLED only)

The Valance Plus has a total height of up to 210 cm. You will need to adapt the actual extension
height required to the conditions on site. You can do this by programming the end position (see
separate instructions).
The cable for the valance motor is laid with protection in a corrugated pipe, through the Arm
profiles.
3.2.4

Scope of delivery

In the case of individual deliveries, the MVLED/MLED remote-receiver is delivered as follows:
•
Remote-receiver with connection leads for the awning, Valance Plus (MVLED only), light and
mains supply
•
Operating instructions
Item number 116692-0000
Version 2 15.11.2013
We reserve the right to make technical
changes
Page 6/28
Assembly and installation instructions