Safety Notes; Fundamental Safety Notes; Dangers Of Electricity; Risk Of Fire When Operating A Radiant Heater (Mvled Only) - weinor BiLine Combio-868 MVLED Assembly And Installation Instructions Manual

Mled remote-receiver for controlling the awning motor and led lighting; mvled for controlling the valance plus
Table of Contents

Advertisement

Available languages

Available languages

BiLine Combio-868 MVLED/ MLED
2

Safety notes

2.1

Fundamental safety notes

Keep unauthorised persons away from the unit until it is ready for use.
The connected electrical load must tally with that listed in the technical data.
The regulations of the local energy providers and the VDE 0100 provisions for humid and wet
areas must be observed.
Only connect the remote-receiver to devices approved by weinor.
2.2

Dangers of electricity

Work involving connections to 230 V mains may only be carried out by a trained electrician.
Disconnect the unit from the power supply before performing any work.
weinor recommendation: a residual current circuit breaker (trip switch) should also be fitted to
protect the indoor installation.
2.3

Risk of fire when operating a radiant heater (MVLED only)

Check the safety function: the awning must extend fully first, followed by the Valance Plus.
The optional heater must be connected and protected with fuses separately (see the heater's
assembly instructions).
2.4

Risks from the Valance Plus (MVLED only)

Check the retraction protection: the awning must extend fully first, followed by the Valance
Plus. In the case of retraction, the Valance Plus must retract fully first, followed by the
awning.
While the Valance Plus is extending, touching it may result in electrostatic discharge.
2.5

Intended use

The Combio-868 MVLED/MLED remote-receiver is exclusively intended for controlling weinor
awning drives and the weinor lighting system.
2.6

Improper use

The remote-receiver may only be used on the condition that a malfunctioning hand transmitter or
remote-receiver does not pose a danger to people, animals or objects. The device may only be
connected to devices and units approved by weinor. The system may not be operated in areas
where the transmitted signals might interfere with other devices (e.g. in hospitals or at airports).
Item number 116692-0000
Version 2
15.11.2013
We reserve the right to make technical
changes
Page 4/28
Assembly and installation instructions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Biline combio-868 mled

Table of Contents